Location:Home > -News > Industry NewsIndustry News

The use of ice machine, ice machine what skills

Time:2014-02-17 14:30:20Source:This siteViews:817

The use of ice machine, ice machine, ice machine what skills?

1, ice making machine, refrigerator, sink water storage and protection film must be cleaned once every two months.

2, the ice to machine back and a right side clearance of not less than 30cm, the tip clearance of not less than 60cm.

3, ice making machines should be used for independent power supply, power supply and a fuse and leakage protection switch, and reliable grounding.

4, ice making machine when not in use, should be clean and dry with a hair dryer, ice model and tank water, put in the non corrosive gas and ventilated dry place, avoid outdoor storage.

5, cleaning the ice machine should turn off the power, prohibit the use of pipe directly aligned body wash, use neutral detergent scrub, prohibit the use of acid, alkali and other corrosive solvent cleaning.

6, ice making machine must be two months to unscrew the hose inlet pipe head, cleaning water inlet valve strainer, prevent sand mud impurities clogging caused by water intake, water becomes small, leading to less ice.

7, ice water to meet the national drinking water standards, and to install water filter, filter water impurities, to prevent blockage of pipes, water and ice mold pollution. And the influence of ice making performance.

8, ice making machine must be every two months to clean the dust surface condenser, condensing heat bad will cause the compressor components. When cleaning, use a vacuum cleaner, a small brush cleaning condensing surface oil and dust, can not use sharp metal tools, cleaning, so as not to damage the condenser.

9, ice making machines should be installed in the far away from heat, without direct sunlight, good ventilation, environmental temperature should not exceed 35 ℃, in order to prevent the environment temperature is too high cause adverse effects of condenser cooling, ice effect. Installation of ice making machine should be on a solid flat surface, ice making machine must be horizontal, otherwise it will cause the noise off the ice and run time.